Descrizione
The USB cable connector type A in male design is designed for mounting on a wire and terminating USB power or data cables. The design consists of a 4-pin USB connector and a black plastic cover, which provides mechanical protection of the contacts and the cable connection point. The product is suitable for service, development and production applications where a standard USB interface with easy assembly is required.
Technical specifications
Connector type: USB type A
Design: male
Number of pins: 4
Interface: USB
Rated voltage: 5V
Rated current: max. 2 A
Working frequency: low frequency use
Assembly: by soldering
Cable entry hole diameter: 3.2 mm
Housing material: black plastic
Composition: USB 4-pin connector + plastic cover
Functions and features
Standard USB A male for common power and data applications
4-pin design corresponding to standard USB interface connection
Cable design allows mounting on your own wire
Plastic cover protects soldered joints from mechanical stress
Suitable for repairs, cable production and prototype use
Simple mechanical assembly after soldering the wires
Ideal for
Production and repair of USB cables
Service and assembly work in electronics
5V power supply with USB type A connector
Data connection of devices with a standard USB A port
Prototypes and custom electronic solutions
Package contents
1x USB connector type A male, 4pin
Why choose this product?
Technically standard solution for USB cable termination
Compact design suitable for practical installation
Possibility of custom wiring according to application requirements
Mechanical connection protection with two-part cover
Suitable for professional and service use in the electronics industry
Installation and operating instructions
Before assembly, verify the correct connection of all 4 pins according to the USB application used.
Connect the wires by soldering, taking into account the heat resistance of the cable insulation.
After soldering is complete, check for short circuits between the contacts.
The cable must match the 3.2 mm entry hole diameter to ensure proper seating in the housing.
After installation, replace the plastic cover to protect the contacts and soldered joints.
Safety notice
The connector is designed for low-voltage USB applications with a voltage of 5 V.
Do not exceed the rated electrical load of the connector.
Perform the installation without connecting the power supply.
The product is not intended for use in environments with excessive humidity or without adequate protection against mechanical damage.
Recensioni
Ancora non ci sono recensioni.